Skip to content
Snippets Groups Projects
Select Git revision
  • 57b000aacceb248d3d47f70f8c9bd1c6b0445b3f
  • master default protected
  • stacked_borrows
  • generics_and_traits
  • crane_lift
  • spans
  • rust_syntax
  • type_check
  • expression
  • fallible
10 results

parser.lalrpop

Blame
  • config 1.76 KiB
    [target.thumbv7m-none-eabi]
    # uncomment this to make `cargo run` execute programs on QEMU
    # runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"
    
    [target.'cfg(all(target_arch = "arm", target_os = "none"))']
    # uncomment ONE of these three option to make `cargo run` start a GDB session
    # which option to pick depends on your system
    # runner = "arm-none-eabi-gdb -q -x openocd.gdb"
    # runner = "gdb-multiarch -q -x openocd.gdb"
    # runner = "gdb -q -x openocd.gdb"
    runner = "probe-run --chip STM32F411RETx"
    
    rustflags = [
      # This is needed if your flash or ram addresses are not aligned to 0x10000 in memory.x
      # See https://github.com/rust-embedded/cortex-m-quickstart/pull/95
      "-C", "link-arg=--nmagic",
    
      # LLD (shipped with the Rust toolchain) is used as the default linker
      "-C", "link-arg=-Tlink.x",
    
      # if you run into problems with LLD switch to the GNU linker by commenting out
      # this line
      # "-C", "linker=arm-none-eabi-ld",
    
      # if you need to link to pre-compiled C libraries provided by a C toolchain
      # use GCC as the linker by commenting out both lines above and then
      # uncommenting the three lines below
      # "-C", "linker=arm-none-eabi-gcc",
      # "-C", "link-arg=-Wl,-Tlink.x",
      # "-C", "link-arg=-nostartfiles",
    ]
    
    [build]
    # Pick ONE of these compilation targets
    # target = "thumbv6m-none-eabi"        # Cortex-M0 and Cortex-M0+
    # target = "thumbv7m-none-eabi"        # Cortex-M3
    target = "thumbv7em-none-eabi"       # Cortex-M4 and Cortex-M7 (no FPU)
    # target = "thumbv7em-none-eabihf"     # Cortex-M4F and Cortex-M7F (with FPU)
    # target = "thumbv8m.base-none-eabi"   # Cortex-M23
    # target = "thumbv8m.main-none-eabi"   # Cortex-M33 (no FPU)
    # target = "thumbv8m.main-none-eabihf" # Cortex-M33 (with FPU)