Motion label
-
Consider placing the motion label on a pin closer to the MISO and MOSI lines of the processor. This will make the wiring easier in the future, as everything from the sensor can go along-side each other.
-
Also consider actually adding the MISO, MOSI and SCLK lines to the MCU. These are needed to communicate with the sensor over the SPI protocol. If you only have the move line connected you can only get an interrupt from the sensor, but you wont know where it moved.
-
Add a line for the reset on the sensor to. Either you connect it to a GPIO on the MCU or to the RST line of the MCU. I recommend the former, as you will have more control over when it will reset in that case. You should also pull the line high by adding a pullup resistor from the rst line to 3.3V, to make sure the line wont float.